Context Navigation

ClosingFocusLoop

-                      v1
+                      v2
      running if you are on trajectory).
    * Start the DMI metrology loop (this will set the DMI focus point).
       NOTE: The DMI focus point is the distance where the focus will be held if you
+            activate the DMI metrology loop.
+      NOTE: The DMI focus point is the distance where the focus will be held if you activate the DMI metrology loop.
    * RA will center a star on OWFS1 or OWFS2.
    * Null out tip/tilt offsets on the OWFS camera of choice.
    * Check that the X and Y offsets are nulled if not have the camera re-centered.
    * Start and activate the metrology loop on the OWFS camera of choice.
       NOTE: By activating the metrology loop on the OWFS camera you are not guiding
+            focus.  This also continuously adjusts the DMI set point.
+      *NOTE: By activating the metrology loop on the OWFS camera you are not guiding focus.  This also continuously adjusts the DMI set point.
    * At the end of the trajectory or when cancelling a trajectory all guiding loops
      will be stopped but the DMI focus set point will still remain until you either