Changes between Version 5 and Version 6 of HetProcedures/TO/degrade

Timestamp:

Sep 26, 2023 11:01:43 PM (8 months ago)

Author:

ccrowe

Comment:

--

HetProcedures/TO/degrade

@@ -22 +22 @@
     2. In SCS, switch Move Authority to ‘None.’ Leave SAMS in closed loop (Operate mode). 
 
-    3. In Wavescope console, enter ‘Degrade X’ where X is the number of minutes you’d like to run the test without moving anything, between 10-30 minutes total. So, for a 10 minute test, you’d type ‘Degrade 10’. For an 18 minute test, ‘Degrade 18’. Run for however much you think you can get in addition to getting a 'Tighten-up' stack.
+    3. In Wavescope console, enter ‘'''Degrade X'''’ where X is the number of minutes you’d like to run the test without moving anything, between 10-30 minutes total. So, for a 10 minute test, you’d type ‘Degrade 10’. For an 18 minute test, ‘Degrade 18’. Run for however much you think you can get in addition to getting a 'Tighten-up' stack.
 
     • If you’re doing a dynamic test, do not move until the Degrade command is done as it will create false measurements, if not crash the test. For example: For a test taking a total of at least 20 minutes, run ‘Degrade 10’, move, return to CCAS and realign, run ‘Degrade 10’ again.