Changes between Version 9 and Version 10 of NightOperations/Commissioning/Plans/20161218

Timestamp:

Dec 18, 2016 7:18:08 AM (7 years ago)

Author:

shetrone

Comment:

--

NightOperations/Commissioning/Plans/20161218

@@ -23 +23 @@
 == Night time engineering: ==
 
-=== CWFS+WFS Loop Constrol Tests ===
+=== CWFS+WFS Loop Control Tests ===
 
  * Make sure your stack is pretty good (RSE < 250)
@@ -42 +42 @@
 === Run full tracks with bib camera+ to assess centroid drag ===
 
- * Use do_shuffle to setup on a V=12 star near start of track  
- * '''See that previous two plans for notes on how we modified the flane.txt file for this.'''
- * Have TO focus up and have RA center at least one OWFS
+ * Make sure your stack is pretty good (RSE < 250)
+ * Make sure GROC is pretty well set
+ * Use do_shuffle to setup on a V=12 star at BIB (position 555 in shuffle) near start of track  
+ * Have TO focus up and have RA center at least one OWFS (preferably OWFS1 since that seems to work better).
  * Use GUI in PAS to move star to bib and hold probes on their targets
- * close focus loop
+ * once focused close the loop on the WFS.
  * set bib exposure to 2sec (for V=12 star) 
  * Record a time in the log
- * Use TO save images button to save gc1,gc2.wf1,wf2,bib images
- * It is good to chek that "Store Images" button is now clicked in all camera gu
- * '''In this test we should NEVER apply X,Y offset corrections'''
- * If TO makes a Tip-Tilt change record the time in the log
- * If TO makes a GRoC correction record the time in the log
+ * Hit "store images" and "Start Metrology Loop"  for GC1, GC2, WFS1, WFS2, TT, CWFS, DMI (although there are no images for DMI)
+ * '''In this test we should NEVER apply X,Y, or GROC offset corrections'''
  * Run until the end of track
  * when done, record a time in the log
@@ -73 +71 @@
        *  Guider should stay in Active mode
        *  Allow guider to catch the star and drag to the final position
-  *  once the guider has setteled to position measure the position on ACAM
+  *  once the guider has settled to position measure the position on ACAM
   *  adjust the dx_ang and dy_ang until you can move from the two locations at will.
   *  update the wiki with the new offset distances and send an e-mail with new values to het-operations